My First Shaker Card

This is a straight-up CASE of a card by Vicky Papaioannu..  I've never really felt compelled to make a shaker card, but I loved the softness and the diffused effect that using vellum gives, so I decided to give my own a go.

To start with I cut three rectangles 12.85cm x 8.5 cm from patterned paper, plain white card and vellum.  To make a frame I measured 1.5cm in from all sides on the back of the white rectangle and then cut the middle section out using a craft knife.  (I may use my Silhouette to make up a load of these rectangles and frames for future use, as I'm pretty rubbish with a craft knife and even this simple task was a bit of a pain!)

I stamped the image and sentiment onto the vellum using silver pigment ink and then covered that with silver embossing powder. Heat embossing happens quickly on vellum so keep the heat tool moving to avoid bubbling.  Then placing the embossed vellum face down, I attached double-sided foam tape around the four edges of the vellum, sprinkled in some sequins then placed the patterned paper rectangle on top (also face down).  And that's the shaker compartment done.

I had intended to use the same patterned paper as a mat for the shaker compartment, but forgot!  Instead I used a lovely bright blue paper, which matched the colour tones of the sequins.  So there you go - my first shaker card!  I don't think it'll be the last...

I'm entering this card into the Simon Says Stamp Wednesday Challenge and The Paper Players Tic Tac Toe challenge (any shade of blue / Embossing / Patterned paper).

Make A Wish

I'm playing along with Freshly Made Sketches 183 .

Here's my interpretation:

I embossed the card blank and used strips of paper to reproduce the sketch.  I also tried working with vellum for the first time - embossing the dandelion seed heads and sentiment in gold.  I thought it would be a good way to add a stamped image without completely obscuring the patterned paper underneath.  I discovered that embossing happens really fast on vellum, and gets really hot! The embossing powder started bubbling at one point.  Also, as I wasn't sure how glue would show up under the vellum, I only glued the outer edge.  In future, I would use a different method. The wet glue caused the vellum to ripple and because it isn't stuck down in the middle, I ended up with a sort of pocket effect.  But having said that I think it looks quite nice.